[Click here for table of contents]

Installation Instructions
For Sectional 20'
and 25' Flagpoles

[Table of Contents]


[Ordering Information]
[line]
[20' Sectional Pole]

Flagpole Installation Instructions:
  1. Dig hole for ground sleeve and mix concrete.

  2. Set sleeve plumb in cement. Temporarily insert bottom section of pole in sleeve and verify installation to be straight using a level. Remove pole section and let concrete harden.

  3. Assemble shaft by sliding sections together. A general purpose sealant can be used on each section if desired.

  4. Mount truck and ball to top of shaft by tightening set screw.

  5. Run halyard through pulley sheave on truck and pull both ends to clear area. Tie in a knot at this point to form a complete loop.

  6. Attach snap hooks to halyard as shown, spaced to accommodate flag.

  7. Wrap excess halyard around cleat to tie off.

  8. Stand flagpole and slide into ground sleeve.

  9. Caulk around pole at the top of sleeve to waterproof at ground level.
Attaching Snaphooks




Slip a loop through eye


Pull loop over snap


Draw tight
[line]
[blue dot] Sectional Flagpoles [blue dot] Outdoor Flagpoles Main Page [blue dot]
[Table of Contents] [Ordering Information] [Home]
Copyright © 1996-2024 CRW Flags Inc. All Rights Reserved
CRW Flags, Inc. - 7306 E. Furnace Branch Rd. - Glen Burnie, Maryland 21060
Website Comments/Suggestions - email  Webmaster  - All other questions or to place an order phone 800-662-6106
Most recent revision to this page - November 3, 2022